Kenworth T440 3464 SPN Fault Code

Name:

Engine Throttle Actuator 1 Control Command

Description:

The control command to throttle actuator 1, normalized to percent, where 0% represents fully closed and 100% represents fully open. Typically, this throttle actuator is used to regulate air or air / fuel mix to the engine. Using the standard convention for determining the position. Left/front is #1 and right/rear is #2 (SPN 3465).FB00h – FB64h is sent to calibrate to a specific position. The LSB specifies the position with a resolution of 1%/bit (eg, FB32h is sent to calibrate the actuator to 50%). FBFFh is sent to calibrate the actuator using its own algorithm. Calibration status from the actuator is received on SPN 5445.

Kenworth T440 3464 spn fault code name is Engine Throttle Actuator 1 Control Command. If you don't take the time to look into Kenworth T440 3464 spn fault when it arises, it can add up quickly. One small issue like Kenworth T440 3464 can cause a larger component to become damaged without taking the time to investigate. If you suspect your truck is suffering from one of these issues, look into replacing those small components to save money down the road.

Note: The name and description of Kenworth T440 3464 code represents text descriptions for faults supported by another coding system and does not necessarily comply with SAE J1939. For a specific engine manufacturer's explanation for codes, please consult the engine's technical manual. See also other spn codes.

Similar SPN Codes :

SPNFMI Faults and Engine error code check tool. SPN code listing with names and descriptions.

About Us | Contact | Privacy

Copyright 2021 - © SPNFMI.com