3336 SPN Fault Code

Name:

Left Desired Blade Offset Operator Control

Description:

This parameter indicates the left blade offset operator control state the user has set for the land leveling system. The left desired blade offset value is the offset measured from a given reference point to the bottom left edge of the blade. This parameter will only be used when the control mode for land leveling system has been set to auto. The purpose of this parameter is to adjust the elevation from a given reference point or the blade angle(also known as blade tilt)/cross slope depending on the function being requested by the operator for the left side of the blade.This parameter is intended for use in systems using two parameters(left/right) to control the blade as described above. Systems using only one parameter to control blade position, i.e. elevation, should use the Desired Blade Offset Switch parameter. Only one of the following states will be active at a time. In the example below, data values are defined for each switch type that may be used in an application. The purpose

3336 spn fault code name is Left Desired Blade Offset Operator Control. If you don't take the time to look into 3336 spn fault when it arises, it can add up quickly. One small issue like 3336 can cause a larger component to become damaged without taking the time to investigate. If you suspect your truck is suffering from one of these issues, look into replacing those small components to save money down the road.

Note: The name and description of 3336 code represents text descriptions for faults supported by another coding system and does not necessarily comply with SAE J1939. For a specific engine manufacturer's explanation for codes, please consult the engine's technical manual. See also other spn codes.

Similar SPN Codes :

Truck List With 3336 SPN Code :

SPNFMI Faults and Engine error code check tool. SPN code listing with names and descriptions.

About Us | Contact | Privacy

Copyright 2021 - © SPNFMI.com